StellaDoradus SD-GDW-O – Boosts Mobile Phone Signal In Ships / Boats, Yachts
- Stock: In Stock
- Brand: StellaDoradus
- Model: SD-RP1002-GDW-O
- Weight: 1.20kg
- Dimensions: 40.00cm x 19.00cm x 13.50cm
- MPN: SD-RP1002-GDW-O
Triple Band: 900MHz / 1800MHz / 2100MHz Frequency Band(s) Support.
The StellaDoradus MarineBoost 3.1 - amplifies the mobile signal it receives, and re-transmit it to an area of your ship, boats, yachts, to where the mini-transmitter antenna is pointed to. The mini-transmitter or basestation can cover an ara of 1000M2.
Features
- Frequency: 900Mhz/1800Mhz/2100Mhz
- Coverage: 1000m2 Open Space (or up to 5 rooms)
- Can boost all mobile network operators (Vodafone, Meteor, Three, Tesco, EIR, etc.)
- CE and RoHS Certified
- No need for existing broadband connection
- Unlimited number of calls/data sessions at the same time
- Complete operator network protection
- Legal to use in Ireland
How the SD-RP1002-GDW-O Works?
The SD-RP1002-GDW MarineBoost 3.1 (3 band 1 port) signal repeater is ideal for small ships/boats. The high gain omni-directional receiver antenna is installed as high up as possible to receive the mobile signal. This receiver antenna takes signal from several base stations on the land, as long as it detect them.
The low-loss SD400 cable runs from the receiver antenna down inside the ship to where the signal repeater is located. An interior panel antenna is connected directly to the repeater. Finally, the 12v power is supplied to the repeater.
That’s the installation done!
How About Signal Range?
When your ship passes within ~30Km of any mobile tower, the SD-RP1002-GDW system is powerful enough to take any mobile signal and amplify them, then re-transmit the boosted signal to your designated area inside your ship, via the indoor transmitter antenna.
What's in the Kit?
In the box, you can find the following:
- The Signal Repeater Unit
- Outdoor Antenna (the receiver antenna)
- Indoor Anntena (the tranmitter antenna)
- Power Supply
- 15m SD400 Cable
Quick Install Guide
We recommend doing a "loose install" to begin with. Do not fasten down the cables until you have found where best to install the various parts.
- Install the outdoor omni antenna somewhere secure on the outside of the ship.
- Cable from this antenna down inside the boat to the location where you want signal.
- Install the booster and indoor antenna here.
- Finally, once you have attached all the cables, plug in the power.
Technical Specifications
| SD-RP1002-GDW Specifications | ||
|---|---|---|
| Frequency Bans (MHz) | 880-960) + (1710-1880) + (1920-2170) | |
| Signal Coverage | 1000m2 (open space) | |
| Number of People | Unlimited | |
| Gain | Uplink Gp > 50dB / Downlink Gp > 60dB | |
| Pass Band Ripple | <4dB | |
| I/O Impedance | 50 ohm/SMA Female Connector | |
| Max Uplink/Downlink Signal Strength | 17dBm / 10dBm | |
| Ambient Temperature | -30°C to +70°C | |
| Power Supply Input | 110 - 240V AC | |
| Power Supply Output | 12v DC | |
| Oscillation Control | Automatic | |
| Level Control | Automatic* | |
| Uplink Switch Off | Yes** | |
| AGC Range | 30db | |
| Surge Protection | SMA connectors DC grounded, 12V DC port MOV protected | |
| Antenna Specifications | ||
| Indoor Antenna | Outdoor Antenna | |
| Nominal Gain | 6.4dBi / 9.4dBi | 4.5dB |
| 3dB Beam Pattern | 60° x 60° | 38º / 35º omni |
| Bandwidth | 790-960MHz + 1710-2700MHz | 790-960MHz + 1710-2700MHz |
| VSWR | <1.4 | <2 |
| Front to Back Ratio | > 20dB | > 20dB |
| Polarization | Vertical | Vertical |
| Power Rating | 50W | 100W |
| Impedance | 50-OHM | 50-OHM |
| Termination | SMA male | N-Female |
| Cross Pol. Discrimination | -20dB | -20dB |
| Dimensions | 210 x 180 x 43mm | 365 x 33mm |
| Weight | 0.68kg | 0.39kg |
| Rated Wind Velocity | 126km/hr | 216Km/h |
| Working Temperature | -40°C to +65°C | -40°C to +65°C |
| Power Supply Specification | ||
| AC | 100-240V 50-60Hz | |
| DC Input | 112V 1.6A | |
| Typical Power Usage | 120W | |
| Mechanical Specification | ||
| Length | 140cm | |
| Width | 119cm | |
| Depth | 13.5cm | |
| Weight | 11.2kg | |
| Mounting | 16x5mm holes for mounting | |
Note, Items with * or ** means the following:
* - Automatically adjusts during installation. Thereafter, automatically adjusts for seasonal variation in pathloss between Basestation and Outdoor Antenna.
** - The uplink amplifiers switch off when the repeater is not in use, thus, reducing the uplink noise to almost zero. When the repeater is in use (eg: phone call being made), the uplink amplifier switches on for the duration of the call and a blue LED switches on, indicating this is the case. Note: Specifications' subject to change without prior notice.
Where to Buy This Tri-Band Mobile Signal Booster?
You can buy this repeater system by simply adding it to your cart and going through the secure and fast checkout process. You can pay using any credit cards supported by Stripe Payment Gateway.
You may also call us to order by dialling the number below.
Contact: +353 222 3440.
Downloads
How Will My Order Be Delivered?
All orders are shipped via express delivery and are normally delivered within 1-4 business days. Your order will be dispatched directly from our warehouse and you will be provided a tracking information for your order, after it is dispatched. If you have any questions on your order status, please contact us.
